1.6 KiB

Raw Blame History

v3.6.1

The z1_sdk is mainly used for communication between z1_controller and command panel(keyboard, joystick, user control panel etc).

Notice

support robot: Z1(v3.6.1) not support robot: Z1(v3.4, v3.5)

Dependencies

build-essential

sudo apt install build-essential

Boost (version 1.5.4 or higher)

dpkg -S /usr/include/boost/version.hpp	# check boost version
sudo apt install libboost-dev			# install boost

CMake (version 2.8.3 or higher)

cmake --version 		# check cmake version
sudo apt install cmake	# install cmake

Eigen (version 3.3.9 or higher)

cd eigen-3.3.9
mkdir build && cd build
cmake ..
sudo make install
sudo ln -s /usr/local/include/eigen3  /usr/include/eigen3
sudo ln -s /usr/local/include/eigen3/Eigen  /usr/local/include/Eigen

Example

There are three examples of command panel control based on SDK in this project, you can use it fllowing the steps below.

State change

First, set(CTRL_PANEL SDK) # z1_ws/src/z1_controller/CMakeList.txt，and then rebuild the z1_ws to generate z1_ctrl, then open a teminal to run z1_ctrl
```
cd /<path to>/z1_controller/build
sudo ./z1_ctrl
```

Sencond, build the z1_sdk, and then open another terminal to run example.

cd /<path to>/z1_sdk && mkdir build && cd build
cmake ..
make -j4
./example_state_send

Low level control

sudo ./z1_ctrl			# Running in a terminal
./example_lowCmd_send	# Running in another terminal

Keyboard control

sudo ./z1_ctrl				# Running in a terminal
./example_keyboard_send		# Running in another terminal

1.6 KiB Raw Blame History Unescape Escape